The first thing we can do to check a cell is to check its appearance. Each cell was produced with a
Tips: It does not mean that all battery cells with QR code are Grade A cells.
As dimension&weight will be slightly different at different SOC percentage, it would be necessary for
you to confirm with the supplier of their testing SOC percentage. Then measure the size at the same
SOC percentage level. And compare the measured value with the one they offered on the datasheet.
Capacity is usually tested at the temperature of 25℃, charging and discharging rate of 1C. Record
the real tested capacity. And compare these two data.
Note: Different temperatures will affect the capacity of lifepo4 battery cells. So some manufacturers
will send you the cell with its capacity a little bit higher than it should be. If your testing capacity is a
little bit higher than the datasheet. If only there aren’t too many differences. That will be alright.
- Internal Resistance
Firstly, confirm the testing environment with suppliers. Including temperature and SOC conditions.
AC internal resistance is usually tested at the frequency of 1000HZ. An AC internal resistance meter
will help you with the testing. For other manufacturers, they will provide DC internal resistance. Then
you may need a multimeter. Compare the real tested data with the one offered in specifications.
- Self-discharge Rate
The self-discharge rate differs at different SOC state. For example, the voltage decrease quicker at
100% SOC than at 50% SOC. So before testing the self-discharge rate, check the battery
specification about the testing SOC state first.
- Capacity Recovery
To test the capacity recovery rate, you just do a 100% DOD charging and discharging cycle. And
check if the capacity recovery rate meets the datasheet.
For example, for a 3.2v 100ah battery cell, if the recovery rate is 95%. We have tested the capacity
at the beginning. It is 100ah. Then after all the tests, we do a 100% DOD charging and discharging.
Then the capacity should be more than 95ah. If yes, the battery capacity recovery rate meets the
datasheet. It's Grade A quality cell.
What we are doing is to compare the testing data with the specification of the cells. So we can trust
the datasheet or supplier. After all the tests and comparison, if all the data meet the specification or
datasheet, it is Grade A cells. If not, it is grade B cells.
Ask your supplier for some samples. And test whether it is Grade A or Grade B cells? Any other
questions, please contact us at: firstname.lastname@example.org.
For detailed video, please check below:
Seplos 3.2V 100Ah LiFePO4 Prismatic Cell: https://bit.ly/3mQz9pI